Welcome to 3D Arts (a 3D Printing Co.)

RAMPS 1.4 CONTROLLER Board New FOR 3D PRINTER REPRAP MENDEL PRUS

  • Model: RAMPS 1.4
  • Shipping Weight: 1lbs
  • 1 Units in Stock

$60.00

Add to Cart:

RAMPS 1.4 CONTROLLER Board New FOR 3D PRINTER REPRAP MENDEL PRUSA TESTED
Package include:

1 x RAMPS 1.4 controller board
5 x A4988 Stepstick Driver

The RAMPS 1.4 board is designed to fit the entire electronics needed for a RepRap in one small package for low cost. RAMPS interfaces an Arduino Mega with the powerful Arduino MEGA platform and has plenty room for expansion. The modular design includes plug in stepper drivers and extruder control electronics on an Arduino MEGA shield for easy service, part replacement, upgrade-ability and expansion. Additionally, a number of Arduino expansion boards can be added to the system as long as the main RAMPS board is kept to the top of the stack.
A4988 driver is a carrier board or breakout board for Allegro's A4988 DMOS Microstepping Driver with Translator and Overcurrent Protection by Pololu; we therefore recommend careful reading of the A4988 datasheet before using this product. This stepper motor driver lets you control one bipolar stepper motor at up to 2 A output current per coil.

moe info


This product was added to our catalog on Thursday 15 October, 2015.

Important Links

Sponsors

Happy Holidays, Happy New year 2016

3d Printing - training - courses

Have you seen ...

Power Supplies and ac adpaters

Who's Online

There currently are 3 guests online.
Your IP Address is: 54.81.94.117
Copyright © 2017 3D Arts. Powered by Zen Cart
3d Printing